| 00:24.33 | Twingy | nobody knows! |
| 03:43.14 | *** join/#brlcad dli (n=dli@adsl-75-33-245-220.dsl.chcgil.sbcglobal.net) |
| 03:55.54 | *** join/#brlcad jack- (i=jack@unaffiliated/q) [NETSPLIT VICTIM] |
| 03:55.54 | *** join/#brlcad ``Erik (i=erik@c-69-250-155-85.hsd1.md.comcast.net) [NETSPLIT VICTIM] |
| 04:08.27 | *** join/#brlcad jack- (i=jack@unaffiliated/q) [NETSPLIT VICTIM] |
| 04:08.27 | *** join/#brlcad ``Erik (i=erik@c-69-250-155-85.hsd1.md.comcast.net) [NETSPLIT VICTIM] |
| 06:08.38 | *** join/#brlcad dtidrow (n=dtidrow@c-69-255-182-248.hsd1.va.comcast.net) |
| 10:28.59 | *** join/#brlcad clock_ (i=clock@84-72-89-40.dclient.hispeed.ch) |
| 10:42.42 | *** join/#brlcad Elperion (n=Elperion@p54877A41.dip.t-dialin.net) |
| 12:28.32 | clock_ | A BRL-CAD model: http://ronja.twibright.com/3d/ronja1_3.png |
| 13:38.41 | clock_ | ``Erik: not yet |
| 13:38.57 | clock_ | ``Erik: the LED position is determined through instinct |
| 13:44.19 | ``Erik | hm, if you put a light source at your 'target' and a "card" down the length of the tube, you should see an X pattern on it, I'd imagine, with the cross being the most instense part :) |
| 13:45.48 | ``Erik | could also use the photon mapping with a fake 'scene' to see if there're ways to configure things to reduce noise at the sensor *shrug* :) |
| 13:50.42 | ``Erik | hrmmmm, yuh oh, hypersample and jitter aren't mentioned in rt's -h |
| 13:51.10 | ``Erik | if you rt with like -H 5, a lot of the aliasing will go away |
| 15:27.21 | *** join/#brlcad dtidrow (n=dtidrow@c-69-255-182-248.hsd1.va.comcast.net) |
| 18:49.29 | *** join/#brlcad clock_ (i=clock@84-72-89-40.dclient.hispeed.ch) |
| 19:01.24 | ``Erik | not too surprisingly, packaged grocery store sushi is not that good. |
| 21:44.26 | *** join/#brlcad IriX64 (n=mario_du@bas3-sudbury98-1168050142.dsl.bell.ca) |
| 21:55.44 | *** join/#brlcad louipc (n=louipc@bas8-toronto63-1088754052.dsl.bell.ca) |
| 22:17.57 | louipc | whois deltazap |
| 22:52.44 | IriX64 | not me ;) |
